Radial Engineering SGI TX Stereo Transmitter for SGI Stereo Instrument Line Driver System Transmitter for Radial SGI Stereo Instrument Line Driver System

aking Radial Engineering's SGI system and enhancing it with a two-channel design, the SGI Stereo TX is the transmitter module of the SGI Stereo system, providing stereo line driving for guitar pedals, pedalboards, and amp modelers. With the ability to send balanced stereo signals up to 300' without loss or noise, this line driver is an ideal tool for stage or studio performances.

The SGI Stereo TX is loaded with premium Jensen transformers to ensure high-quality sound and a natural tone for off-stage amps and processors. The unit sports two 1/4" Hi-Z inputs for stereo input (such as stereo FX pedals or keyboards), stereo Hi-Z thruputs for feeding unbalanced signals to local amps and DI boxes, and a locking RJ45 EtherCON output that delivers balanced analog audio. The Stereo SGI TX supports 9 to 18 VDC power input and includes a 15V power supply.

Using the SGI Stereo in the Studio

The SGI Stereo is the perfect interface for studio recording. Now, you can sit in the control room and play guitar and actually hear what is coming through the monitors while you play. Simply connect your guitar or pedalboard via two 1/4” instrument cables to the TX, run a single standard Cat 5 Ethernet cable to the RX, and crank to your heart’s content.

Using the SGI Stereo on Stage

The SGI Stereo is a ready-made solution for large stages where high-impedance guitar signals are often affected by the capacitance of long cables or noise due to lighting systems. The SGI Stereo balances the signal from your pedalboard and delivers it without noise. Perfect for isolation cabinets, under stage amps, or remote quiet rooms.

A Solution to Complex Routing Systems

The SGI Stereo system is a wonderful tool for helping manage complex setups on stage. You can also use an original SGI to route the signal from a wireless receiver to your pedalboard, then use a pair of SGI Stereo units to drive your stereo pedalboard output to remote guitar amplifiers and drive signals up to 300' without noise.

Radial SGI TX Stereo Features:

• Transmitter unit for Radial’s SGI Stereo instrument line driver system
  
• When coupled with the SGI RX receiver, the system takes dual unbalanced 1/4-in. instrument signals and drives them up to 300 ft. via Cat 5 Ethernet
  
• Defeats the diminished top-end detail and noise often introduced by long 1/4-in. cable runs
  
• Boasts a premium Jensen transformer to send your signal with a wide, flat frequency response, reduced noise, enhanced dynamic range, and an optimized signal-to-noise ratio
  
• 9–18V DC power input to accept most pedalboard-standard power supplies